Power Flushing

After a Power Flush Your Boiler Will Run More Efficiently, Quietly and Will Save You Money on Your Gas Bills.

From the very first day that your central heating is commissioned, its efficiency starts to drop. Within a few months a system can lose 10% of its efficiency. Sludge is created due to the chemical reaction that takes place when copper pipe is exposed to hot water. This circulates around the central heating system and eventually settles in the radiators. This sludge seriously affects the performance of the system and can in many cases lead to boiler failure and expensive repairs.

If you have any questions or would like to request a free quotation please call us on 0208 578 5523 or 07956965930 or email us.

This diagram, courtesy of Kamco, shows symptoms of a clogged central heating system:

Symptoms identified and resolved

  • Cold spots in radiators
  • Noisy boiler or pipes
  • Heating slow to warm up
  • Boiler cutting out
  • Reduced efficiency – higher bills
  • Frequent venting (bleeding) needed
  • Potential pump failure and seizure

Many systems are also found to contain corrosion and sludge, even if no flow problems have yet shown themselves.

Our power flushing employs a high velocity flushing pump and specialist materials to remove built up rust and dirt inside your central heating system. This is then flushed out and replaced with clean water.

We have two of the best tools available, the Adey Magnacleanse and the Kamco cf90.

"Richard has over the past few years fixed leaking pipes, changed old pumps, serviced and cleaned our underfloor manifolds, installed new boilers and water softener. He is reliable, friendly and trustworthy - will always call you back and help you out when he can. We’ve always been delighted with Richards work and would have no hesitation in recommending him. He’s a great find."

Joanna Green